JD Electrical Services is an approved electrician in Rosegrove, covering Rosegrove and the west side of Burnley. Rewires, consumer units, EICR testing, EV chargers and lighting, open 6am to 11pm every day.
Home > Locations > Rosegrove
Our Services in Rosegrove

Electrician work in Rosegrove covers consumer unit replacement, full house rewires, partial rewires, fuse box replacement, EICR testing and CCTV. Old boards with rewirable fuses are still common and give no protection against a shock. Swapping one takes most of a day, and we test every circuit before and after.
As an electric vehicle charging station contractor we fit home and smart EV chargers across Rosegrove, and repair units that have stopped or keep tripping. The charger goes on its own circuit with the correct protection, and we handle the notification to the network operator as part of the job.

Lighting contractor work in Rosegrove includes LED downlight installation, security lights at back doors and passages, outdoor lighting and light fitting replacement. Sensor position matters more than brightness on a security light, so we aim and tune it before leaving rather than just putting it on the wall.
JD Electrical Services covers Rosegrove and the areas next to it, including Lowerhouse and Gannow. We have been trading for 10 years as approved electricians, so every job is tested, registered and certificated. We work 6am to 11pm seven days a week and take emergency call outs 24 hours a day.
Approved electricians with 10 years behind us
Open 6am to 11pm, seven days a week
Emergency call outs available 24 hours a day
Price agreed in writing before work starts
Certificate issued at the end of every job
Rosegrove is close to us, so emergency call outs are usually attended quickly and we cover them 24 hours a day. If you have lost power or a breaker will not reset, switch that circuit off and call. We will tell you an honest arrival time on the phone.
Yes, mostly over back doors, driveways and side gates. Getting the sensor set across the approach rather than straight down it is what makes a security light useful. We adjust the range and angle so it is not triggering every time a cat walks past.
Yes. We test the existing circuits first, because old boards often hide poor earthing or damaged cable. The new board goes on with RCD protection, each circuit is reconnected and tested, and the work is registered. Power is usually off for three to five hours.
t: 07576 586580
Mon: 6am - 11pm
Tue: 6am - 11pm
Wed: 6am - 11pm
Thu: 6am - 11pm
Fri: 6am - 11pm
Sat: 6am - 11pm
Sun: 6am - 11pm
© Copyright 2026. JD Electrical Services. All rights reserved.
Business address: 2 Orpen Avenue, Burnley, BB11 2PB