LED Downlight Installation in Burnley

LED downlight installation in Burnley for kitchens, bathrooms, hallways and whole houses. LEDs use a fraction of the power of halogen and last for years. We use fire rated fittings and test the circuit afterwards.

Working Out How Many You Need

Too few downlights leave dark corners, too many make a room look like an office. A typical kitchen needs about one every square metre, angled to light the worktops rather than the middle of the floor. We mark the positions on the ceiling before cutting anything.

More Information

Fire Rated Fittings and Ceiling Safety

Cutting holes in a ceiling weakens the barrier that slows a fire spreading between floors. Fire rated downlights seal the hole back up when they get hot. They are required in most ceilings between floors, and we fit them as standard rather than as an extra.

Dimming and Colour Temperature

LEDs come in warm white, which suits living rooms, and cooler white, which suits kitchens and bathrooms. If you want them dimmable, the fitting and the switch both have to be made for it, or they flicker and buzz. We match the pairing so it works properly.

About us

LED downlights are one of the most common jobs JD Electrical Services takes on in Burnley homes, usually when a kitchen is being redone or when halogen lamps start failing one after another. We have been trading for 10 years, and the work is tested and certificated like any other circuit.

  • Approved electricians with 10 years behind us

  • Open 6am to 11pm, seven days a week

  • Emergency call outs available 24 hours a day

  • Price agreed in writing before work starts

  • Certificate issued at the end of every job

STILL NOT SURE?

Frequently Asked Questions

How many LED downlights do I need in a kitchen?

As a rough guide, one fitting per square metre of ceiling, spaced evenly and set back from the walls so they light the worktops. A small kitchen might take six, a large one twelve. We mark them out and let you see the layout before any holes are cut.

Can I replace halogen downlights with LED myself?

Swapping a lamp in an existing fitting is straightforward. Changing the fittings themselves means working on the lighting circuit and cutting the ceiling, which has to meet the fire rating requirements and be tested afterwards. Most people have that part done properly.

Do LED downlights get hot?

They run far cooler than halogen, but the driver still gives off some heat, so the fitting needs the clearance the maker specifies and insulation must not be packed against it unless the unit allows it. Fire rated units are built for this. We check the loft while fitting.

Our reviews